Connected and Smart Gas Alarm
Comprehensive gas alarm for hazardous substances with push/email messages
Comprehensive gas alarm for hazardous substances with push/email messages
The gas alarm built into the air-Q responds sensitively to various hazardous substances. If the configured limit values are exceeded or fallen below, the gas alarm is triggered along with an acoustic and visual alarm on the air-Q. If push notifications are enabled, every device in the air-Q Cloud receives push and email notifications for the fire and smoke alarm.
- Carbon Monoxide (CO): > 200 mg/m³
- Oxygen (O₂): < 13.0%
- Ozone (O₃): > 1,000 µg/m³
- Nitrogen Dioxide (NO₂): > 20,000 µg/m³
- Ammonia (NH₃): > 100,000 µg/m³
- Chlorine/Chlorine Gas (Cl₂): > 50,000 µg/m³
- Hydrogen Sulfide (H₂S): > 50,000 µg/m³
- Methane (CH₄): > 0.5%
Depending on which sensors are present, the air-Q gas alarm is triggered at the following threshold values:
Fire and smoke alarm with push/email messages
The air-Q has a built-in fire alarm (or smoke alarm) that triggers an acoustic and visual alarm on the device. By combining several high-quality sensors, the air-Q acts as a very fine and precise smoke detector that triggers significantly earlier. Optionally, the fire/smoke alarm can also be configured as a push notification and email notification.
- Carbon Monoxide (CO): > 230 mg/m³
- Air Temperature (T): > 70 °C
- Particulate Matter (PM₁): > 400 µg/m³
- Particulate Matter (PM₂.₅): > 500 µg/m³
- Particulate Matter (PM₁₀): > 600 µg/m³
Note: The air-Q cannot be used as a legally required smoke detector, since requirements regarding installation location and independence from mains power aren’t met. The air-Q is powered via a power cable rather than by battery. However, the air-Q can complement an existing smoke detector, detecting and notifying about potentially dangerous situations more precisely thanks to its additional sensors, and thus potentially raising the alarm earlier — possibly decisively so.
More Information on the air-Q’s Gas Alarm
→ To the contact form